Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Which X-Carve is Right for You? Learn More.

CNC TOOL STORAGE

5 likes
49 opens
24 copies
0 comments
chris patty

Project by

chris patty

General Information

Not all mine!! I just moved, twisted and turned to make it work for me!!
I did use piece of 2×12 that was laying around so I could cut deeper pockets for certain tools and did leave about an inch on 1 side just in case I want to add a couple things later!

Like this project Open in Easel®
1

Open in easel and hit carve!! lol

90 minutes

I would check the depths and make them work with your material! some of mine are 1" deep, so be careful!!