Cutting Board Juice Grooves

‹ ›

19 likes

262 opens

104 copies

3 comments

Project by

Melvin Rooter Woodworks
Las Vegas, USA

General Information

Freud 18-108 round nose bit.
.2 in overall depth
-100 ipm
-9 in plunge
-.025 in depth per pass.

I was still learning when I made this. If I were to do it again today, I would speed up the ipm, maybe even up to 200 ipm. and I would do .1 depth per pass.

Like this project Open in Easel^®

what was your feed rate? Plunge rate? Depth per pass? Thank you
Nick Stocksdale

.2 in overall depth, 100 ipm, 9 in plunge, .025 in depth per pass. I was still learning - if I were to do it again today, I would speed up the ipm, maybe even up to 200 ipm. I would do .1 depth per pass.
Melvin Rooter Woodworks

its not uploading
Bernardo Barajas