Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Jesus_Cross_Layered

15 likes
274 opens
128 copies
3 comments
Shannon Dolese

Project by

Shannon Dolese
Lucedale, USA

General Information

Copy of Jesus_Cross layered with 3/4" Dark Walnut and 1/8" Hard Maple. Carved deep enough through the maple to allow the Walnut to show as the background. Also added outside with optional stand layout

Like this project Open in Easel®
tom
What size cnc machine did you use and how did you carve the top of the cross? Did you use a 3018 like your project very much
tom
Shannon Dolese
Xcarve 1000. Don’t understand the question about how the top was cut.
Shannon Dolese
Shannon Dolese
However, I glued a piece of 1/8" maple to 3/4" walnut for contrast and set the top cut to slightly deeper than the maple to clear to the walnut. Using purpleheart is also nice contrast.
Shannon Dolese

Log in to post a comment to the designer