Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Which X-Carve is Right for You? Learn More.

Milling Aluminum DW660 Mounts

38 opens
12 copies
Caleb Peters

Project by

Caleb Peters

General Information

I made some new DW660 mounts. The mounts are made from 1/2 inch aluminum, and I think they are going to work out quite nicely.

Like this project Open in Easel®

Detailed Video Here

360 minutes

It still hard to believe that a ShapeOko 2 can mill 1/2 inch Aluminum, but it will do it with very little complaint.

Andrew Forsberg
Nice slotted wasteboard- what is it and where did you get it?
Andrew Forsberg
Caleb Peters
Go to: And, used the part number: HFSQN4-15250-500
Caleb Peters