Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Which X-Carve is Right for You? Learn More.

Paw Prints

189 opens
79 copies
Ryan Goetzmann

Project by

Ryan Goetzmann
Skaneateles, New York

General Information

Inlay of a Paw Prints using a 1/16" bit.

All tool paths have been changed on the original picture to make the edges smoother and to accommodate the tight corners to allow the bit size.

Like this project Open in Easel®
Derek Shoemake
What is the offset setting on these?
Derek Shoemake
Ryan Goetzmann
I use a .0015" Tolerance with a 1/16" bit
Ryan Goetzmann