Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Rev 41 1476

4 likes
25 opens
2 copies
526 downloads 0 comments
Jon Anderson

Project by

Jon Anderson

General Information

A REV bracket at 30 degrees out of aluminum

http://www.revrobotics.com/rev-41-1476/

Like this project Open in Easel®
Material Description Price
Aluminum Sheet 6061

Aluminum Sheet 6061

Dimensions: 12 in × 12 in x.062 in, Thickness: .062 in

$16.34

Carbide Tip Upcut 2 Flute -  1/4 in Cutting x 1/4 in Shank

Carbide Tip Upcut 2 Flute - 1/4 in Cutting x 1/4 in Shank

Shank Diameter: 1/4 in, Cutting Diameter: 1/8 in, Cutting Length: 1/2 in

This project's Bill of Materials is not complete.

$16.34
from Inventables

File Description Unit Price

REV-41-1476.dxf

$0

Download Zip

$0
from Inventables

1

Secure aluminum to fixture

5 minutes

Use the ‘12×12 Sheet Fixture’:https://www.inventables.com/projects/12×12-sheet-fixture to secure the aluminum using rigid double sided tape or painter’s tape and CA glue strategy.

Note:
REV uses 2mm (about 0.080") aluminum for these brackets.
YMMV depending on your application with 0.062" thick aluminum which is 80% as thick as the 2mm aluminum.

2

Carve aluminum

5 minutes

Carve the aluminum using the Easel project.

Notes:
– Use lubricant/cooling to extend the life of the bit
– Use a brush or compressed air to remove the chips to improve finish and extend the life of the bit

3

Release the part

3 minutes

Release the part using a knife, chisel, putty knife or similar. The whole sheet can be removed easily using the screwdriver/prybar release slot on the bottom of the fixture’s cutting area.

4

Debur

5 minutes

Debur the part as needed.