Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Square and L Clamp, XCP w/ Countersunk holes

17 likes
263 opens
142 copies
4 comments
Matt Slaga

Project by

Matt Slaga
Jacksonville, USA

General Information

I needed an L clamp and side clamps, but with the screws countersunk into the material. I do a lot of surface planing and wanted to protect my bits from hitting screws.

Like this project Open in Easel®
Hiram Mingo
Hi, What wasteboard was this made for. I have the new modular board will the corner brace work with it
Hiram Mingo
Matt Slaga
I used this on the original XCP 4' x 2' wasteboard, and on the newer 2x2 with T slot wasteboard. The new XCP wasteboard has the same hole dimensions (but NOT the same as the original XC)
Matt Slaga
Katrina Schmitt
i just cut this and it didn't screw/holes match up to my xcarve wasteboard.
Katrina Schmitt
Matt Slaga
This was designed for the x-carve pro, there is another for the x-carve 1000.
Matt Slaga