Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Which X-Carve is Right for You? Learn More.

Stratocaster Guitar Pick Tray

0 likes
50 opens
15 copies
0 comments
Melvin Rooter Woodworks

Project by

Melvin Rooter Woodworks
Las Vegas, USA

General Information

Roughing pass was done with a .75" bowl bit with a 40% stepover. Finishing pass with the same bit with a 5% stepover. Detail engraving done with a 90-degree V bit. Outline was cut out with a 1/4" downcut bit.
Masked with oracal for black detail, rounded the sides, finished with 2 coats of shellac.

Like this project Open in Easel®