Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

Wasteboard engraving 5cm2

217 opens
49 copies
Christian Lie Eikefjord

Project by

Christian Lie Eikefjord
Bergen, Norway

General Information

To engrave a 5cm grid onto your wasteboard.

Usefull for the ones that diy their own.
Use the smallest bit that followed in the geting started. Or a V-bit

Depth is set at 1.5mm, i did run it with 0.5mm and i discovered some sagging on my board.

Like this project Open in Easel®