Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

x carve bit storage

40 likes
369 opens
135 copies
5 comments
Phillip lunsford

Project by

Phillip lunsford

General Information

By popular request I am sharing this file with the community. This bit storage tray has worked very well for me. I hope you enjoy the project.

Like this project Open in Easel®
Fabio dos Santos
ONCE AGAIN! THANK YOU!
Fabio dos Santos
marie jordan
Good morning i am very new to cnc and your videos are spot on teaching me the do's and don't but learning the right bits are very confusing in this project you stated 0.120 what ecactly is that , any help with bits would be greatly appreciated sincerly angela
marie jordan
Bill
Very nice. Brand new and wanting to try this when my machine arrives. Are you OK with me using this design??
Bill
Jim Stephens
so for the wording under each. Did you just laser engrave that?
Jim Stephens
Phillip lunsford
The letters were cut on the CNC then painted and sanded off the excess paint
Phillip lunsford