Email Support | Mon - Fri: 9am - 5pm Sun: 12pm - 4pm CT | Call Support: 312-775-7009

X-carve tool holder (3of3)

134 likes
1726 opens
737 copies
1 comment
Chip Clark

Project by

Chip Clark

General Information

I designed this holder for my vernier and height probe to match the clamp holder and bit holder. 3/4" MDF with the top edge finished with a 1/4" round over bit in on my router table.

Like this project Open in Easel®
Ben Brito
Hi Chip, i'm trying to make your tool tray but when i try to change to material and size tab it opens the oops page saying somethigs gone wrong and to refresh the page but still no joy. i've tried on 2 different laptops and the same thing happens. any advise would be helpful. thanks. Ben
Ben Brito